Dynamic width with Checkbox selection mode

[ReonyParticipant]

Currently, if we have Checkbox as the selection mode, and have a percentage width or 100% width for our table (grid), the math for adding the columns up to 100% width total, always ends up with a gap still after the last column. Can you guys update your code so that the Checkbox selection column, automatically gets subtracted from the total percentage? That way, the last column can always be flush to the right side. Thanks!

Screenshot:

[ReonyParticipant]

Since screenshot image isn’t rendering inline, here is link to screenshot: http://pasteboard.co/1ViDP45w.png

[HristoParticipant]

Hello Reony,

Thank you for using our product and for this suggestion.

Best Regards,
Hristo Hristov

jQWidgets team
http://www.jqwidgets.com

[SouldatParticipant]

I’m having the same problem with version 4.1.2. Any updates on this issue? Is it ever going to be resolved?

Thanks.

[HristoParticipant]

Hello Souldat,

Thank you for your interest, expect in some later versions.

Best Regards,
Hristo Hristov

jQWidgets team
http://www.jqwidgets.com

[bjpetalParticipant]

I too, would like to see this implemented… As it is it makes it hard to have a nice, tight fitting grid. I always get horizontal scrollbars.

[HristoParticipant]

Hello bjpetal,

If you calculate your columns width and it is equal to the Grid’s width then there should not have a horizontal scrollbar.
Also, you could create one of the columns to be without width. In that way, it will be automatically calculated and the Grid will be prevented from appearing of the horizontal scrollbar.

Best Regards,
Hristo Hristov

jQWidgets team
http://www.jqwidgets.com

[Author]

Posts